Ford F-150 04-07 PATS Programming Installation Instructions
Before beginning:
Please ensure that you did match your part number as these units are part number / family number specific, not vehicle specific. If your part number is not in the listing description, please contact us with your part number and we can determine if this is the correct replacement. Do not begin the next steps until this is verified as this can cause a locksmith to be needed to move forward.
The engine will not start until you complete the following steps:
Perform the following steps to program the ignition keys:
YOU MUST HAVE TWO NON-CLONED, CHIPPED KEYS PRIOR TO BEGINNGING THIS STEP, THEY MUST BE PROGRAMMED AT THE SAME TIME. ATTEMPTING WITH ONE KEY OR WITH A KEY THAT IS CLONED OR NON-CHIPPED WILL REQUIRE A LOCKSMITH TO CORRECT THE ISSUE
- Turn the ignition to OFF.
- Turn key 1 in the ignition to ON for 3 seconds, then remove.
- Turn key 2 in the ignition to ON for 3 seconds, then remove.
- Repeat step 3 for additional keys if required. After programming the necessary number of keys, proceed to step 5 below.
- After you finish, confirm all programmed keys can start the engine. Verify the engine continues to run for at least 5 seconds.