10-11 CROWN VIC GRAND MARQUIS ECU ECM PCM ENGINE COMPUTER AW7A-12A650-AA TESTED

AW7A-12A650-AA - See interchange below

ECU will require programming by your local mechanic and is not plug and play.

This ecu will interchange or replace the following ecu part numbers on 2010 and 2011 Ford Crown Victoria and Mercury Grand Marquis models with a 4.6L :

AW7A-12A650-AA

AW7A-12A650-CA

AW7A-12A650-MA

AW7A-12A650-PA

ECU has been rebuilt/tested with our state of the art vehicle simulator which tests over 25 circuits of the ECU! Some of those are listed below:
• If ecu had common P0443, O2 sensor or purge issues it has been rebuilt!
• Reference Voltage Good!
• ECU powered up and has communication!
• ECU fuel pump/main relay tested good!
• ECU injectors/coils tested good and much more!

• Disconnect the negative terminal of the battery. Make sure the battery connector is not touching the battery post.
• Disconnect and remove the module to be replaced.
• Install and connect the replacement module.
• Connect the negative terminal of the battery.
• See "Programming / PATS Security" below for additional install instructions.

For Plug and Play you must do the following three steps:

Step 1: Match your part number per above fitment guide

Step 2: Program ecu to your VIN. Your local mechanic and possibly your locksmith can perform this programming for you.

Step 3: If your vehicle has PATS security (Most Ford/Lincoln/Mercury's do) you must have your keys programmed. We recommend you have this done by your local locksmith. In most cases they will travel to your location and the process takes less than 30 minutes. No towing necessary and your local locksmith will be cheaper than a dealer.

• Mounting points are all open and intact
• Pins perfect, none are broken or bent
• Lock tabs in place

This ECM comes with a 90 day warranty from the date of purchase. Please keep a copy of your purchase record which we will send with your item.